Financial

3 Lessons Learned: Resources

Waterjet Cutting Cost

It is only fair to acknowledge the popularity that waterjet cutting has gained over the years. It is hardly uncommon for one to seek to understand the cost of waterjet cutting. It is necessary to understand that there are various costs incurred in running waterjet cutting processes. You will find that there are various consumables and power requirements that will have to be addressed. It is certain that water and abrasive will attract given costs too. You will actually note that there are ideally six different configurations. They attract different costs. It is for this reason that it will be valuable for you to understand some of the costs attracted by this waterjet cutting. They will in most cases consist of the following.

Water does attract some costs. You will actually find that this is what will cost you the least among all. This water will be effective in cutting as well as cooling. Usually, 3.5 dollars will be used for each 1000 gallon. This will go ahead to cost you a figure of between 1200 and 2500 dollars each year. It is however necessary for you to keep in mind that you will be required to pay for the sewer too. This will in most cases be determined by the location. There are regions that will cost more than the others. It is necessary to understand that the intensifier pump will also have to be operated. This will often depend on power. You will learn that it will be required of you to use around 3700 to 9400 dollar annually for power. This will however depend on the usage. These figures are pegged on the use of pumps of between 50 and 125HP.

Abrasive comes at a cost too. It will often turn out to be the most costly of all. You will learn that there are basically two types of garnet available. There is usually the hard rock garnet and the alluvial one. You will learn that hard rock is known to be sharper. This is why it will tend to cut faster. The alluvial garnet will often come with rounded grains. This is what will raise the cost of the hard rock. There is also a need for you to consider the cost attached to the abrasive flow rate. It will in most cases cost you an amount that ranges between 26000 and 55000 dollars year after year.

It will also be necessary for you to take into account the cost of wear and tear. Replacement of certain parts such as orifice will be quite common. We have miscellaneous pump part costs too. They will attract a cost of up to 32000 yearly.

Where To Start with Resources and More

On Machines: My Experience Explained